12 GB/CY
Set the comb attachment on the blade (see fig. C). Ensure that the
comb attachment
6
,
7
fastens audibly and sits tightly.
Switch the appliance on. Move the comb in the opposite direction to
the hair growth, and from the outer tip of the eyebrow towards the
nose (see Fig. D).
To trim hair just above the skin surface, remove the comb attachment
6
,
7
and guide the blade
2
directly over the skin in the desired area.
Note: To trim only individual hairs, adjust the angle of the blade and
guide this against the individual hairs.
Cleaning, care and storage
Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning agents. These might
damage the surface of the product.
Clean the housing with a dry cloth.
Take off the comb attachment
6
,
7
(see fig. C) and clean the blade
carefully under running water (see fig. E). Then fully dry the blade
before using the product again.
Attention: The product is only protected against splash water. Never
immerse it in water. Otherwise, irreparable damage may result.
I
f there are still hairs in the the blade, clean it with the a soft brush
8
(s
ee fig. F).
To store the device, always put on the protective cap
1
.
Keep the device in a cool, dry location.