5.Frozen milk must first be left in the refrigerator to thaw naturally. If you need it urgently, put it in a bowl of warm water
and thaw it. After thawing, the milk can be stored in the refrigerator for 24 hours.
6.NEVER FREEZE MILK AGAIN.
7.Frozen milk can be gradually warmed in warm water or placed in a baby bottle warmer.
8.NEVER WARM YOUR BREAST IN THE MICROWAVE, BECAUSE YOU CAN DESTROY VITAL NUTRIENTS AND ANTIBODIES
THIS WAY. Also, uneven heating can lead to too hot areas of breast milk, which can cause burns to your baby's upper
digestive tract. Never place a frozen bottle of milk in boiling water, as this may cause the bottle to burst / break. Never
pour boiling water directly into a feeding bottle. You should allow the water to cool for about 20 minutes before filling the
bottle.
X. CLEANING AND STERILIZATION OF THE PUMP
1.1.Important: NEVER CLEAN WITH WATER or STERILIZE THE PUMPING MECHANISM, CONNECTING TUBE AND THE
ADAPTER FOR CHARGING THE BATTERY. You can only clean it with a soft dry cloth.
2.Clean and sterilize your electric pump before first use and after each use, following the instructions below.
3.We recommend using an electric sterilizer, microwave sterilizer or boiling to clean the pump.
4.Do not use a UV sterilizer or dishwasher to clean the pump
5.STERILIZATION:
•Remove the pump mechanism (D) and set it aside. Separate all other parts, wash them in warm soapy water and dry
them. Do not use antibacterial or corrosive cleaners.
•Sterilize ONLY the following parts: Silicone massaging pad (A); Horn mouth and pump body (B); Silicone diaphragm (C);
Valve (E); Feeding bottle (F); Bottle gap (G); Bottle ring (H); Dust shield (J); Sealing Disc (K).
•Maximum sterilization time in a steam or boiling sterilizer is about 8 to 10 minutes.
6.RECOMMENDATIONS FOR CLEANING
•Use a steam sterilizer. Boiling the parts is not recommended. The first reason is that the product will be easily damaged if
improper sterilization is applied. Second, this method of sterilization cannot achieve full effect.
•If you do decide to use boiling as a sterilization method, pour more water into the container so that the parts are
completely covered with water. You must not leave the product unattended during the sterilization process. Do not boil
for too long - maximum 10 minutes.
•For breastfeeding mothers who breastfeed every 2-3 hours, we do not recommend sterilizing and cleaning after each
use. Excessive disinfection and cleaning can easily lead to premature aging of parts and shorten the life of the breast
pump. Thorough cleaning of stains and sterilization once a day is recommended.
•Store the parts in a clean container until the next use.
IMPORTANT! If you use the breast pump as a means of storing milk, you must take care to disinfect all washable parts of
the pump, because otherwise, the milk can easily spoil, as it is a product that is difficult to store.
ATTENTION! Before use, make sure that the pump body, valve, piston and cover are dry.
•If you use a steam sterilizer to clean the pump parts, you must take care that they do not come into contact with the
sterilizer heater. And if you use boiling as your sterilization method, be careful that the parts do not come into contact
with the bottom of the container you are boiling in.
•When not using the product for a long time, it is recommended to charge the battery once a month.
15
XI. TROUBLESHOOTING GUIDE
1. Lack of suction:
•Make sure that you have not blocked or covered the air opening of the pump body.
•Check if you have assembled all parts correctly and if the valve is positioned correctly.
•Ensure that the silicone massage pad is fitted securely to the pump body and a perfect seal is created.
•Check if you have placed the silicone valve firmly to the opening of the pump body.
•Check whether there are any damaged parts.
If you can not turn the pump on, check whether the battery is exhausted. Connect the adapter to the terminal for
charging the motor. Do not use it while charging as it shortens battery life
2. No milk is being expressed:
•Check point 1
•Ensure the pump is correctly assembled and that suction is being created.
•Relax and try again.
•We recommend you increase the levels gradually; the most suitable level is the one, with which the suction is painless.
The following is NOT true: the stronger – the better. Too strong suction can hurt the nipple.
3. Pain in the breast area where there is expression:
•If you feel pain and no milk flows during expression, maybe your mammary gland is blocked.