6 GB/CY
Safety / Before initial use
General safety information
DANGER
TO LIFE AND ACCIDENT
HAZARD FOR TODDLERS
AND SMALL CHILDREN! Never allow
children to play unsupervised with the packag-
ing material. There is a danger of suffocation
from the packaging material. Children frequently
underestimate the dangers. Children should
be kept away from the product at all times.
DANGER TO LIFE! Batteries can be swal-
lowed, which may represent a danger to life.
If a battery has been swallowed, medical
help is required immediately.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.
Do not use the device if it is damaged. Dam-
aged devices represent a danger of death
from electric shock!
Please note that the guarantee does not cover
damage caused by incorrect handling, non-
compliance with the operating instructions or
interference with the device by unauthorised
individuals.
Under no circumstances should you take the
device apart. Improper repairs may place
the user in considerable danger. Repairs
should only be carried out by specialist
personnel.
Safety instructions
for batteries
Remove the batteries from the device if they are
not going to be used for a prolonged period.
CAUTION! DANGER OF EXPLOSION!
The batteries must never be recharged!
When inserting the batteries, ensure the
correct polarity! This is shown in the battery
compartments.
If necessary, clean the batteries and device
contacts before inserting the batteries.
Remove spent batteries immediately from the
device. There is an increased danger of leaks!
Batteries must not be disposed of in the
normal domestic waste!
Every consumer is legally obliged to dispose
of batteries in the proper manner!
Keep batteries away from children. Do not
throw batteries into a fire. Never short-circuit
them or take them apart.
Always replace all the batteries at once.
Use batteries of the same type only.
If the above instructions are not complied
with, the batteries may discharge themselves
beyond their end voltage. There is a danger
of leaking. If the batteries have leaked inside
your device, you should remove them immedi-
ately in order to prevent damage to the device!
Avoid contact with the skin, eyes and mucous
membranes. Any parts of the body coming
into contact with battery acid should be
rinsed off with copious amounts of water
and / or a doctor contacted if necessary!
Before initial use
Setting up devices
CAUTION! When selecting a location to
set up the devices, please ensure that they are
not exposed to any direct sunlight, vibrations,
dust, heat, cold or moisture. Do not place the
devices close to sources of heat, e.g. radiators.
Otherwise they may be damaged.
Place the weather station on the accompany-
ing base
35
.
Note: Please ensure that the pins in the
stand
35
are inserted into the corresponding
recesses on the weather station.
Do not place the devices on valuable or sen-
sitive surfaces unless these are appropriately
protected. Otherwise they may be damaged.
Do not place the devices near sources of in-
terference such as television sets, computers,
thick walls, thermopane windows etc. Other-
wise the transmission of radio waves between
the devices may be impaired.
Please ensure that neighbouring devices are not
operated at the same frequency of 433 MHz.
Such devices may cause interference to the
radio connection.
Do not place the devices next to or on metal
plates. Otherwise the quality of radio wave
transmission may be reduced.
Do not install the devices in buildings made
of reinforced concrete, e.g. airports, high-rise
buildings, factories or cellars. Otherwise the
transmission of the radio waves between the
devices may be severely impaired.
In open spaces do not place the devices more
than 30 metres apart, as otherwise transmission
of the radio waves may be interrupted.
Putting the outdoor
sensor into operation
Removing the battery safety strip:
Remove the battery compartment cover from
the back of the outdoor sensor.
Remove the battery safety strip. The outdoor
sensor is now ready for operation and the
control LED
36
lights up briefly.
Close the battery compartment cover.
Installing the Outdoor Sensor:
Note: For this step you need a drill.
Find an appropriate place for the outdoor sensor.
Note: Please ensure that you install the
outdoor sensor within a radius of 30 m from