![](//vs1.manuzoid.ro/store/data-gzf/7cb5cd6e90f622ffad2641a6b002c8fb/2/000157911.htmlex.zip/bg8.jpg)
IMPORTANT RECOMMANDATIONS
• The voltage of your electrical installation must correspond to that of the
iron (220-240V). Always plug your iron into an earth socket. Connecting to
the wrong voltage may cause irreversible damage to the iron and will
invalidate the guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated
(16A) with an earth, and is fully extended.
• If the electric power cord is damaged, it must be replaced by an Approved
Service Centre in order to prevent any danger.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold
it under the water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when
you are ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your saftey, this appliance conforms to the applicable standards and
regulations (Low Voltage, Electromagnetic Compatibility, Environmental
Directives).
• This product has been designed for domestic use only. Any commercial
use, inappropriate use or failure to comply with the instructions, the
manufacturer accepts no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST !
i Your appliance contains valuable materials which can be recovered or
recycled.
‹ Leave it at a local civic waste collection point.
Keep these instructions
2
DESCRIPTION
BEFORE USE
WARNING ! Remove any labels from the soleplate before heating up the iron.
WARNING ! Before using your iron with the steam function for the first time, we recommend
that you operate it in a horizontal position for a few moments, away from your linen, i.e. press
the Shot of Steam button a few times.
Upon the first use, you may notice small particles coming out of the soleplate. This is parf of
manufacturing process and is not harmful to you or your garments. It will disappear after
several uses. You may accelerate this by using the self cleaning function (fig 5a – 5b) and
shaking the iron gently.
1 • What water may be used ?
Your iron has been designed to operate using untreated tap water. If in doubt, check
with your local water authority. However, if your water is very hard, you can mix
50% untreated tap water with 50% distilled or demineralised water.
IMPORTANT Heat concentrates the elements contained in water during evaporation. The
types of water listed below contain organic waste or mineral elements that can cause
spitting, brown staining or premature wear of the appliance : water from clothes dryers,
scented or softened water, water from refrigerators, batteries or air conditioners, pure
distilled or demineralised water or rain water should not be used in your iron. Also do not use
boiled, filtered or bottled water.
IRONING BOARD: Due to the powerful steam output, a mesh type ironing board must be used
to allow any excess steam to escape and to avoid steam venting sideways.
1 Spray nozzle
2 Filling inlet
(with slide-button opening)
3 Eco steam system
a Dry ironing
b ECO position
C BOOST position
4 Self Clean
5 Spray button
6 Shot of steam button
7 Cord
8 Handle
9 Thermostat control light
10 Temperature control dial
11 Water tank
12 Maximum water level indicator
13 Soleplate
14 Auto-Off*
15 High Precision TIP
(*) Depending on model
1103909971-index 01 DW6000 F1_110x220mm 24/11/14 15:53 Page2