Stokke® iZi Go Modular™ user guide
10EN
Thank you for choosing
Stokke® iZi Go Modular™ by Besafe®
It is important that you read this user manual BEFORE installing your seat. Incorrect
installation could endanger your child.
IMPORTANT! KEEP FOR FUTURE REFERENCE.
Vital information
• The child seat MUST NOT be installed in a front passenger seat
WITH AN ACTIVATED AIRBAG.
• Stokke® iZi Go Modular™ by Besafe® can be installed rearfacing on iZi
Modular i-Size base or can be installed rearfacing with a 3-point car belt, approved
according to UN/ECE Regulation No.16 or other equivalent standards.
• Stokke® iZi Go Modular™ by Besafe® is approved for children with a stature height from
40 to 75 cm, with a max. weight of 13 kg.
• The harness straps must always be locked when the child is in the seat.
• The harness straps must be tightened without slack and not twisted.
• The shoulder pads contain magnets. Magnets can inuence electronic equipment such as
pacemakers.
• Protect any part of the child’s body which is exposed to the sun.
• Remove the head space reducers on both sides from the headrest when the child is older
than 3 months or if the head is not tting anymore. These reducers can be removed by
opening the velcro on the back of the head rests.
• Remove the baby cushion (bottom part) when the child is taller then 60 cm, or over 4
months.
• Remove the baby cushion (bottom part) and body hugger (upper part) when the child is
taller than 65 cm, or over 6 months.
• After an accident, the seat must be replaced. Although it may look undamaged, if you
were to have another accident, the seat may not be able to protect your child to the level
to which it was designed.
• Prevent the seat from becoming trapped or weighed down by luggage, seats and/or
slamming doors.
• Make sure you can t no more than one nger between the harness and your child (1 cm).
• DO NOT attempt to dismantle, modify or add any part to the seat. Warranty will be void if
non-original parts or accessories are used.