EN MY4523 - User manual
5
Floor mopping Robot
Frequent Asked Questions
Cleans Multiple Floors
The MY4523 works on wood, carpet, tile, vinyl, and linoleum, and adjusts automatically to
different floor types.
The MY4523 automatically senses stairs and other cliffs. It might stall when
confronting rounded edges and might slide over particularly slippery surfaces.
Anti-Tangle System
The MY4523 won’t get stuck on cords, carpet fringe or tassels. When it detects that it had
picked up a cord or tassel, it will automatically stop its main brushes or side brush and try
to escape. It may make a clicking noise when anti-tangle is activated.
1. Big room cleaning: Press twich (2 times) the Switch On/Off button to start, it cleans 60
minutes and stops automatially;
2. Small room cleaning: Press Once (1 time) the Switch On/Off button to start, it cleans 30
minutes and stop automatically.
Q: Why does the Side Brush occasionally spin backwards?
A: When caught on items such as carpet tassels or wires, the Side Brush may spin slowly or
briefly spin backwards to free itself. This may also occur on thick or high-pile carpets. If this
behavior should occur on hard floor surfaces or when on tassels or wires are presented, the
Side Brush should be cleaned. Using a small screwdriver, to move the screw from the center
of the Side Brush first, then remove the Side Brush and clean any hair or debris wrapped
around the shaft thoroughly. Re-install the Side Brush properly after cleaning it.
Q:Why does MY4523 accasionally make a squeaky sound?
A: When its brushes encounter items such as carpet tassels or wires, the brushes will briefly
reverse direction to get free. This action causes a squeaky sound that can be heard
approximately once per second until the brushes are free from obstruction. If your MY4523
makes such a sound when no tassels or wires are presented, the main brush/side brush
should be cleaned.
Q: Why doesn’t MY4523 slow down as it approaches certain obstacles?
A: The MY4523 uses its light Touch Bumper technology to identify walls and other obstacles,
allowing it to slow down and gently touch the obstacles with its bumper before changing
direction. It may be less effective at sensing and slowing down from extremly dark or black
surfaces, or for objects that are less than two inches wide.
Floor mopping Robot
Important Safety Instructions
►This appliance should only be used for domestic cleaning, as described in this user guide.
►Always switch off and remove the charger from the socket before cleaning the appliance
or any maintenance task.
►This Appliance can be used by children aged from 16 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance.
►If the power cord is damaged, stop using the appliance immediately. To avoid a safety
hazard, an authorized service engineer must replace the power cord.
If the area to be cleaned containers a balcony, a physical barrier should be used to prevent
access to the balcony and ensure safe operation.
►Small children and pets must be supervised while the cleaner is cleaning.
►Use only the original charger supplied with the appliance. Check that your supply voltage is
the same as that stated on the charger.
►Leaks from battery cells can occure under extreme usage or temperature conditions. If the
liquid gets on skin, wash quickly with water. If the liquid gets into eyes, flush them immediately
with clean water for a minimium 10 minutes. See medical attention.
►It is normal for the charger to become warm to the touch when charging.
Don’t pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items.
►Don’t spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours.
►Don’t continue to user your appliance or charger if it appears faulty.
►To ensure the continued safe and efficient operation of this appliance we recommend that
any servicing or repairs are only carried out by an authourised service engineers.
►Don’t replace the robot batteries with non-rechargeable batteries.
►End of life battery removal. If the appliance is to be disposed, the batteries must firstly be
removed. It must be disconnected from the supply mains when removing the battery.