17
HVU2 en
WARNING
Poor load values / potential failure of fastening due to oversetting. Stop rotation of anchor rod immediately when the embedment depth is reached.
–
–
– Use the setting machine at a speed of 450–1300 RPM to drive the anchor rod into the hole, applying moderate pressure. Switch off the setting machine
right up to the concrete surface. Caution! Prolonged rotary action may cause mortar to be forced out of the hole, resulting in poor load values / potential
failure of fastening.
–
Poor load values / potential failure of fastening due to inadequate borehole cleaning
–
– Borehole must be free of dust, water, ice, oil, bitumen, chemicals or any other foreign matter or contaminants.
– Clean the borehole right before setting the anchor. Remove drilling dust and standing water from the base of the hole by blowing out well with at least 4
Not adhering to these setting instructions can result in failure of fastening points!
For diamond cored holes:
–
Please replace the brushes.
– For requirements at application temperature below 0°C, contact Hilti.
For overhead application:
Loading or manipulation of anchor rod is not allowed within the curing time «t cure».
Overhead application is not permitted for HVU2 M27 and M30
Warranty: Refer to standard Hilti terms and conditions of sale for warranty information.
or unique applications may affect the reliability or performance of the fastenings.