12
To reset the blender, turn the knob
to OFF position and then to ON
position again.
3
Turn the knob to a blending speed
setting (min to max) or press
the pulse button to process
ingredients as needed.
4
Press the air release button on the
lid when you nish processing (the
LED light ring is fully on) (step 9 in
g.3).
5
Remove the jar from the motor unit
and open the lid.
6
Pour out the jar contents.
Pulse and ice crushing
functions
To process ingredients briey (such as
garlic), press and hold the pulse button
for a few seconds, and then release it.
Repeat the procedure several times.
To crush ice, press the ice crushing
button . To stop processing before
the program ends, press the selected
program button again or turn the rotary
knob to the OFF position.
Note
• After one minute processing for ice
crushing, the blender will stop the process
automatically.
• Do not blend dry ingredients (for example
pepper corn or star anise).
• If you press the vacuum button or the
vacuum and blending button during or
after blending, the blender enters the error
mode and the error message (vacuum error
icon ) lights up (Fig. 3-1). To reset the
blender, turn the knob to OFF position and
then to ON position again.
•
To stop, press the vacuum and
blending button again.
•
If you accidently rotate the speed
knob during the vacuum process,
the blender enters the error mode
and the error message (vacuum error
icon ) lights up (g. 3-1). To reset
the blender, turn the knob to OFF
position and then to ON position
again.
•
When the vacuum operation
completes, the blender
automatically starts to process the
ingredients (i.e. smoothies) for the
preset time and then stop.
3
Press the air release button on
the lid when the processing is
completed (the LED light ring is fully
on) (step 9 in g.3).
4
Remove the jar from the motor unit
and open the lid.
5
Pour out the jar contents.
Manual vacuum and blending mode
1
Prepare your blender (step 1 to step
6 in g. 3).
2
Press the vacuum button .
» The blender automatically prepares
a vacuum connection to the
vacuum module. It then starts to
vacuum the jar and the LED ring
lights up to indicate the vacuum
progress. When the vacuum process
is completed (the LED light ring
is fully on), the blender enters the
standby mode.
•
To stop during the vacuum process,
press the vacuum button again.
•
If you accidently rotate the speed
knob during the vacuum process,
the blender enters the error mode
and the error message (vacuum
error icon ) lights up (g. 3-1).