WEAR PERSONAL PROTECTIVE EQUIPMENT
• Wear safety glasses according to En166
• Use protective masks in accordance with En149
• Use other types of proper personal protective equipment, depending on the type of work involved.
Description of equipment
Storage
Store cordless tools in a dry place and out of the reach of children. For safety concerns, remove the
battery pack from the cordless tool before storage. When left connected to a cordless tool, the battery
pack is drained faster. Protect the battery pack and power tools from frost, high temperatures,
moisture and water.
Do not attempt to repair a failed battery pack. Only the original manufacturer or an authorised service
may repair the battery pack.
Recharge the battery packs using only the chargers specified by the manufacturer.
Storage or operation of the battery pack in unsuitable conditions may result in a battery acid leak.
Never attempt to use a damaged or modified battery pack. Damaged or modified battery packs may
cause unpredictable effects during operation, resulting in health hazards. Keep the battery pack away
from open flames and high temperature. If exposed to fire or temperatures above 130°C, the battery
pack may explode.
Installing the battery pack
Tip: Using a battery pack incompatible with the power tool may result in abnormal performance or
failure of the power tool.
Insert the battery pack into the handle until the battery pack latch clicks (the battery pack should be
flush with the receptacle edges on the power tool).
Blade installation:
Make sure the device is disconnected from the power source.
The device is equipped with a rapid blade installation system (SDS).
Turn the SDS chuck.
Place the blade in the chuck.
Release the SDS clamping ring.
When replacing the blade make sure that:
The blade holder is free from other materials
Always check that the blade is securely clamped before use.
Blade removal:
Remember to wait after work because the blade may be hot.
Make sure the device is disconnected from the power source.
Rotate the saw blade chuck SDS ring
and remove the blade from the chuck.
8
CR7010
1. Foot
2. SDS chuck
3. Power & speed control switch
4. Switch locki
5. Foot adjustment button
6. Undercutting switch
7. Handle grip
8. Air vent
9. Blade
10. Battery charge indicator
11. State of charge indicator button
12. Battery pack latch release button