5019 318 33225
SAFEGUARDING THE ENVIRONMENT
1. Packaging
Packaging materials are 100% recyclable and are marked with the
recycling symbol .Dispose of the appliance in conformity with
local environmental regulations. Packaging materials (plastic bags,
polystyrene, etc.) can be dangerous for children and should be kept
well out of their reach.
2. Product
This appliance is marked in compliance with European Directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is scrapped suitably, you can help
prevent potentially damaging consequences for the environment and
health.
The symbol on the appliance or accompanying documentation
indicates that this product should not be disposed of as unsorted
municipal waste but must be taken to a collection point for the
treatment of WEEE.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal.
For further information on the treatment, recovery and recycling of this
appliance, contact your competent local authority, the collection service
for household waste or the shop where you purchased the appliance.
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
WARNING!
• The appliance is not intended for use by young children or
persons with restricted physical, sensory or mental
abilities or without experience and knowledge of the
appliance, unless they are under the supervision or
instruction of a person responsible for their safety.
• Make sure children do not play with the appliance.
1. Do not connect the appliance to the mains power supply until
installation has been fully completed. Always disconnect the hood
before cleaning or carrying out maintenance by unplugging it or
switching off the power supply.
2. Do not “flambé” food under the hood. Naked flames could cause a
fire.
3. Do not leave pans unattended when frying. Cooking oil can catch
fire.
4. Regular cleaning and maintenance is essential to correct functioning
and good performance. Regularly remove dirt deposits. Regularly
clean or replace filters. Never use flammable materials as hoses for
extracted air.
5. If the hood is used together with other appliances powered by gas
or other fuels, ambient negative pressure must not exceed
4Pa (4 x 10-5 bar). For this reason, make sure the room is
adequately ventilated.
6. Exhaust air must not be conveyed through the same flue used by
the heating system or other appliances powered by gas or other
fuels.
7. The room must be adequately ventilated when the hood is used
together with appliances powered by gas or other fuels.
8. When replacing the bulbs, first ensure that they are cold.
9. The discharge air must not be ducted to a flue used for removing
fumes produced by appliances using gas or other fuels, but must
have a separate outlet. All national regulations on air discharge
must be observed.
10. The hood is not a shelf. It must not be overloaded or used to
carry objects
Note:
always wear work gloves for all installation and maintenance
operations.
Electrical connections
The mains power supply must correspond to the voltage indicated
on the appliance rating plate located inside the hood. If it is fitted
with a plug, connect the hood to a power socket that complys with
applicable standards and is in an easily accessible location. If it is not
fitted with a plug (direct connection to the power supply) or if the
socket is not in an easily accessible location, fit a two-pole switch in
compliance with regulations, to ensure complete disconnection from
the mains voltage in conditions of category III overvoltage, according
to the rules for proper installation.
WARNING: Before reconnecting the hood circuit to the
mains power supply and checking correct operation, make
sure the power cable is correctly fitted and that it was NOT
crushed in the housing during installation.
Cleaning the hood
Warning!
Failure to remove oil and grease (at least once a month) could
lead to fire.
Use a soft cloth with a neutral detergent. Never use abrasive
substances or alcohol.
Before using the hood
Please read these instructions carefully and keep them for future
reference, in order to ensure best use of your hood.
Packaging materials (plastic bags, polystyrene, etc.) can be dangerous
for children and should be kept well out of their reach.
Make sure the hood has not been damaged during transport.
Declaration of conformity
This product has been designed, manufactured and sold in
conformity to the following standards:
- safety objectives of “Low Voltage” Directive 73/23/EEC
- protection requirements of “EMC” Directive 89/336/EEC
amended by Directive 93/68/EEC.
Troubleshooting guide
The hood does not work:
• Is the plug properly inserted in the power socket?
• Is there a power failure?
The hood is not extracting efficiently:
• Is the right speed selected?
• Do the filters need cleaning or replacing?
• Are the air outlets blocked?
The light does not work:
• Does the bulb need replacing?
• Is the bulb correctly fitted?
AFTER-SALES SERVICE
Before calling the After-sales Service
1. Check if you can fix the problem yourself
(see “Troubleshooting guide”).
2. Switch the hood off and then on again to check if the problem
has gone.
3. If the problem persists, contact the After-sales Service.
Specify:
•the nature of the problem,
• the model of hood, stated on the data plate inside the hood,
accessible by removing the grease filters.
• your full address,
• your telephone number and area code.
• the service code (the number appearing below the word
SERVICE on the data plate inside the hood behind the grease
filter).
If any repairs are needed, contact an authorised Service Centre (to
ensure that only original spare parts are used and that repairs are
made correctly).
Failure to comply with these instructions may compromise the safety
and quality of the product.
PL SK H RUS
CZ
BG RO GB