– 5
DANGER
When using detergents, the material data safety sheet
issued by the detergent manufacturer must be adhered
to, especially the instructions regarding personal pro-
tective equipment.
Do not fill or suction detergent or other additives into the
tank.
Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
Rinse off loose dirt.
ATTENTION
Risk of damage to the paintwork
When working with the universal brush, it must be free
of dirt or other particles.
Illustration
Install the universal brush.
Release the lever on the trigger gun.
After another 5 minutes without being pressed, the de-
vice shuts off automatically.
To avoid damage:
Remove the tank or suction hose.
Turn on the appliance.
Push the lever of the trigger gun until no more wa-
ter is emitted.
Release the lever on the trigger gun.
Completely empty the tank.
If necessary, reinsert the fine filter and valve opener.
ATTENTION
Appliances and accessories that are not completely
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.
몇 CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
The supplied Li-ion battery has been checked in accord-
ance with the relevant regulations for international
transport and is permitted to be transported / dis-
patched.
Observe regulations for dangerous goods during
transport.
Lift appliance by the carrying handle and carry it.
Secure the appliance against shifting and tipping
over.
몇 CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing it.
Park the machine on an even surface.
Do not store the device at temperatures above
40°C and under 0°C.
DANGER
Risk of electric shock.
Turn the device off and disconnect from the charg-
er before carrying out any tasks on the device.
Clean valve opener and fine filter regularly.
ATTENTION
Valve opener and filter must not be damaged.
Illustrations -
Remove the valve opener and fine filter using the
suction hose connection or a suitable pair of pliers.
Clean the valve opener and fine filter under running
water.
Reinsert the fine filter and valve opener.
Note: Ensure that the pin of the valve opener
points upwards.
DANGER
Turn the device off and disconnect from the charger be-
fore carrying out any tasks on the device.
Repair work and work on the electrical components may
only be performed by an authorised customer service.
You can rectify minor faults yourself with the help of the
following overview.
If in doubt, please consult the authorized customer ser-
vice.
Check the battery's charging state and charge it if
necessary.
Motor overloaded, the motor circuit breaker has tripped.
Turn off the appliance.
Switch on the device and put it into operation again.
At ambient temperatures below 0°C or above 40°C, the
motor circuit breaker will be tripped.
Turn
off the appliance.
Allow device to cool down/heat up.
Switch on the device and put it into operation again.
If the malfunction occurs repeatedly, have the device
checked by the customer service.
Make sure there is enough water in the tank or wa-
ter container.
Clean the valve opener and fine filter under running
water.
Make sure that the valve opener is inserted with the
pin pointing upwards.
Clean the nozzle: Remove contamination and de-
bris from the nozzle drill, using a needle and rinse
through with water towards the front.
Make sure there is enough water in the tank or wa-
ter container.
Dropwise leakage of the device is normal for tech-
nical reasons. If the leakage increases contact the
authorized customer service.
Operation with detergent
Operation with universal brush
Interrupting operation
Finish operation
Transport
When transporting by hand
When transporting in vehicles
Storage
Storing the Appliance
Care and maintenance
Clean valve opener/fine filter
Troubleshooting
Appliance is not running
Pressure does not build up in the appliance
Strong pressure fluctuations
Appliance is leaking