19
CAUTION:
Before using the cross blade, check the
gasket to make sure it is not damaged
and it is completely seated in the cross
blade unit before each use.
Never put your hands or utensils near the
moving cross blades and never use your
hands or utensils to press the activator
buttons down while the motor base is
plugged in.
IF THE CROSS BLADE STOPS
SPINNING WHILE IN LOCK ON MODE,
IMMEDIATELY UNPLUG THE MAGIC
BULLET® Hard ingredients like carrots
or celery can get stuck in the cross blade
and stop it from turning. If this happens,
UNPLUG THE MAGIC BULLET® RIGHT
AWAY Remove the blade/cup assembly
from the motor base, and give ingredients
a good shake to unblock the cross blade.
If the cross blade still remains obstructed,
twist the cross blade attachment o of the
cup and carefully spin the metal blades
using a utensil (not your fingers) to release
the blockage. Reattach the cross blade to
the cup, plug in the Magic Bullet® and try
again. It should spin normally.
NEVER RUN THE MAGIC BULLET
FOR MORE THAN ONE MINUTE AT A
TIME, AS IT CAN CAUSE PERMANENT
DAMAGE TO THE MOTOR If the motor
stops working, unplug the motor base
and let it cool for a few hours before
attempting to use it again. Your Magic
Bullet® has an internal thermal breaker
that shuts the unit o when it overheats.
Letting the thermal breaker cool down
should allow it to reset.