Hood / User Manual 9 / EN
3 Using the appliance
3.1 Controls panel
L Light Switches the lighting system on and off.
V Speed Sets the operating speed of the extractor:
0. Speed switches the extractor motor off.
1. Low speed, used for a continuous and
silent air change in the presence of light
cooking vapour.
2. Medium speed, suitable for most ope-
rating conditions given the optimum
treated air flow/noise level ratio.
3. Maximum speed, used for eliminating
the highest cooking vapour emission,
including long periods.
•The extractor hood has been designed exclu-
sively for domestic use to eliminate kitchen
smells.
•Never use the hood for purposes other than for
which it has been designed.
•Never leave high naked flames under the hood
when it is in operation.
•Adjust the flame intensity to direct it onto the
bottom of the pan only, making sure that it does
not engulf the sides.
•Deep fat fryers must be continuously monitored
during use: overheated can burst into flames.
3.2 Efficient use in terms of
energy saving
•When using your appliance, adjust the speed
settings according to vapour and odour intensity,
in order to save energy.
•Use low speeds (1-2) under normal conditions,
and high speed (3) and boost mode for intense
odour and vapour.
•The hood is equipped with lamps in order to illu-
minate the cooking area.
•Using them for environmental lighting shall
cause unnecessary energy expenditure and in-
sufficient lighting.
•For your device to consume less energy, run it at
a low speed level.
•Your device will reduce energy consumption as
it will run more efficiently when you provide suf-
ficient air intake to it.
•Set your device to the intense suction power
level before the formation of steam, in cases
where you know that the dense steam will occur.
So, you reduce energy consumption by using
your device for a shorter time as it will have a
sufficient air intake.
•Keep the lids of the cookware closed to reduce
the steam evolving.
3.3 Operating the Hood
•Hood is equipped with a motor having various
speed settings.
•For a better performance, we advise you to use
low speeds in normal conditions, and high spe-
eds when smell and vapors are intensified.
•You can start the hood by pressing the desired
speed level key.(V1,V2,V3 )
•You can illuminate the cooking area by pressing
the light key L ( )
3.4 Lamp replacement
A
•Before replacing the light bulbs,
disconnect the power supply of
the hood.
•Do not touch the light bulbs when
they are hot.
•Be careful not to touch the repla-
ced light bulb directly with hands.
CYou may procure lamps from
Authorised Service Agents.